Sony Handycam HDRSR11 Operating Manual page 10

To charge the battery pack using only
the AC Adaptor
Turn the POWER switch to OFF (CHG),
then connect the AC Adaptor directly to the
DC IN jack on the camcorder.
With the v mark
on the right
Available running time for the
supplied battery pack
Charging time:
Approximate time (min.) required when
you fully charge a completely exhausted
battery pack.
Recording/Playback time:
Approximate time (min.) available when
you use a fully charged battery pack.
"HD" stands for high definition image
quality, and "SD" stands for standard image
quality.
Charging time
Recording time*
Continuous
recording time
Typical
recording
time*
3
Playback time*
US
10
POWER switch
DC IN jack
DC plug
Open the jack
cover.
(Unit:min.)
"Memory
Hard disk Stick PRO
HD SD HD
135
*
1 2
85 105 90
40 50 40
130 130 140
2
*
1 [REC MODE]: SP
*
2 When the LCD backlight is on
* 3 Typical recording time shows the time when
you repeat recording start/stop, turning the
power on/off and zooming.
On the battery pack
• When you remove the battery pack or
disconnect the AC Adaptor, turn the POWER
switch to OFF (CHG) and make sure that the
(Movie) lamp/
ACCESS lamps (p. 13, 17) are turned off.
• The power will not be supplied from the battery
as long as the AC Adaptor is connected to the
DC IN jack of your camcorder or the Handycam
Station, even when the power cord (mains lead)
is disconnected from the wall outlet (wall
socket).
On the charging/recording/playback time
• Times measured when using the camcorder at
25°C (77°F) (10°C to 30°C (50°F to 86°F) is
recommended).
• The available recording and playback time will
be shorter when you use your camcorder in low
temperatures.
• The available recording and playback time will
be shorter depending on the conditions under
which you use your camcorder.
On the AC Adaptor
• Use the nearby wall outlet (wall socket) when
using the AC Adaptor. Disconnect the AC
Adaptor from the wall outlet (wall socket)
immediately if any malfunction occurs while
using your camcorder.
• Do not use the AC Adaptor placed in a narrow
space, such as between a wall and furniture.
• Do not short-circuit the DC plug of the AC
Duo"
Adaptor or battery terminal with any metallic
objects. This may cause a malfunction.
SD
• Even if your camcorder is turned off, AC power
source (mains) is still supplied to it while
connected to the wall outlet (wall socket) via the
AC Adaptor.
105
50
140
(Still) lamp (p. 11)/