Table of Contents
Advertisement
Picture or sound noise when viewing a TV
channel
Make sure that the antenna is connected
using a 75-ohm coaxial cable (not supplied).
Keep the antenna cable away from other
connecting cords.
To avoid TV interference, make sure to use an
undamaged antenna cable.
Tiny black points and/or bright points
appear on the screen
The picture of a display unit is composed of
pixels. Tiny black points and/or bright points
(pixels) on the screen do not indicate a
malfunction.
Picture contours are distorted
Change the current setting of [CineMotion] to
other settings (page 17).
No color on programs
Select [Reset] (page 17).
No color or irregular color when viewing a
signal from the Y, P
Check the connection of the Y, P
/
and check if each jacks are firmly
seated in their respective jacks.
No picture from the connected equipment
appears on the screen
Turn the connected equipment on.
Check the cable connection.
Press INPUT to display the connected
equipment list, then select the desired input.
Correctly insert the memory card or other
storage device in the digital still camera.
Use a digital still camera memory card or
other storage device that has been formatted
according to the instruction manual supplied
with the digital still camera.
Operations are not guaranteed for all USB
devices. Also, operations differ depending on
the features of the USB device and the video
being played.
Cannot select the connected equipment
on the menu or cannot switch the input
Check the cable connection.
34
US
, P
jacks of
/
B
R
, P
jacks of
B
R
Sound
No sound, but good picture
Press VOL +/- or MUTING.
Check if [Speakers] in [AV Setup] is set to [TV
Speakers] (page 22).
Check if the headphone plug is connected to
the TV.
No sound or noisy sound
Check if the TV system setting is appropriate
(page 18).
Channels
The desired channel cannot be selected
Switch between [Cable] and [Antenna] to
select the desired digital/analog channel.
Some channels are blank
The channel is for scrambled/subscription
service only. Subscribe to a pay TV service.
Channel is used only for data (no picture or
sound).
Contact the broadcaster for transmission
details.
General
The TV turns off automatically (the TV
enters standby mode)
Check if the [Sleep Timer] is activated
(page 22).
Check if the [Duration] is activated by [On
Timer] (page 22) or [Photo Frame Settings]
(page 20).
Check if the [Idle TV Standby] is activated
(page 24).
Some input sources cannot be selected
Select [Manage Inputs] and select [Always] of
the input source (page 22).
The remote control does not function
Replace the batteries.
HDMI equipment does not appear on
BRAVIA Sync Device List
Check that your equipment is compatible
with BRAVIA Sync Control.
Cannot select Off in BRAVIA Sync Control
If you have connected any audio system that
is compatible with BRAVIA Sync Control, you
cannot select [Off] in this menu. To change
the audio output to the TV speaker, select [TV
Speakers] in the [Speakers] menu (page 22).
Advertisement
Table of Contents
