How To Reset The Inverter To Factory Defaults - Invertek Optidrive E3 Series Easy Start Manual

Easy Start Guide
Invertek Optidrive E3 Inverter (IP20, 3ph output)

14. How to reset the Inverter to Factory Defaults

This guide has been produced by The Inverter Drive Supermarket Ltd.
All content, including but not limited to graphics, text and procedures copyright
Drive Supermarket and must not be reproduced or altered without prior written permission.
14.1 Three Button Reset
To reset all parameters to their factory default values,
press and hold the up, down and stop keys together for
approx. 2 seconds.
The display will show "P-dEF" to indicate "Parameter
Defaults".
14.2 Confirm the Reset
Press the red stop key to confirm the reset.
The display will show "StoP" indicating that the process is
complete.
14.3 Enable Extended or Advanced Parameters (optional)
Parameters above P-14 will not be visible once a factory
reset has been completed.
If access to "extended" parameters (P-15 to P-50) is
required, set P-14 to 101. For "advanced" parameters (P-
15 to P-60) set P-14 to 201.
Note: see section 6 to learn how to set a parameter
value.
© The Inverter
Page 14