Table of Contents
Advertisement
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1.
MAINTAIN A SAFE WORKING ENVIRONMENT. Keep the work area well lit.
Make sure there is adequate surrounding workspace. Always keep the work
area free of obstructions, sawdust, grease, oil, trash, and other debris. Do not
use the Table Saw in areas near flammable chemicals, dusts, and vapors. Do
not use the Table Saw in a damp or wet location.
2.
GROUND THIS PRODUCT. The electrical Power Cord for this product is
equipped with a grounded, 3-Prong Plug. Never remove the grounding prong or
modify the Plug in any way. Do not use adapter plugs with this product. To
comply with the National Electric Code, and to provide additional protection from
the risk of electrical shock, this product should only be connected to a 120 Volt,
3-hole electrical outlet that is protected by a Ground Fault Circuit Interrupter
(GFCI).
3.
DO NOT ABUSE THE POWER CORD. Do not use the Power Cord to pull its 3-
Prong Plug from an electrical power outlet. Keep the Power Cord away from
heat, oil, sharp edges, and moving parts. Route the Power Cord safely. Do not
route the Power Cord where it can be walked on or tripped over. Replace a
damaged Power Cord immediately.
4.
IF AN EXTENSION CORD (not included) IS USED, MAKE SURE TO USE
ONLY UL APPROVED CORDS HAVING THE CORRECT GAUGE AND
LENGTH. (See Figure A.)
REQUIRED MINIMUM EXTENSION CORD GAUGE – 120 VOLT
NAMEPLATE
AMPERES
16.1 – 20.0
5.
REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the Power
Switch (part #91) is in the "STOP" position before plugging the Power Cord into a
grounded, 3-hole, 120 Volt, electrical outlet.
(See Assy. Diagram.)
6.
PRIOR TO STARTING THE TABLE SAW, MAKE SURE ALL ADJUSTING
KEYS AND WRENCHES ARE REMOVED FROM THE TOOL.
SKU 04333
EXTENSION CORD LENGTH
0 - 25
25 - 50
Feet
Feet
12
10
FIGURE A
50 - 100
Feet
-
PAGE 4
100 – 150
150 – 200
Feet
Feet
-
-
Advertisement
Table of Contents
