Cleaning And Caring For The Camera - Dometic PERFECTVIEW CAM45 Installation And Operating Manual

CAM45
Establishing the electrical connection for the camera
I
NOTE
•
Lay the camera cable so that, should you need to remove the camera, you can
access the plug connection between the
camera and the extension cable easily. This greatly facilitates the disassembly.
•
To minimise corrosion in the plug, apply a small amount of grease, such as pin
grease, in one of the plugs.
➤ Insert the camera cable plug into the socket for the extension cable.
➤ Screw on the plug connection of the connecting cables to protect against water penetration
(fig. g, page 7).
Aligning the camera
I
NOTE
To do this you must first install and electrically connect a monitor (see schematic
connection diagram fig. h, page 7).
➤ Align the camera using the image on the monitor to help you:
The monitor image should show the rear or the bumper of the vehicle at the bottom edge of
the screen. The middle of the bumper should be in the middle of the screen (fig. i, page 7).
➤ Check the function of the camera after you have connected it to a monitor.
Fastening the camera
➤ Tighten the two fastening screws in the slots on the monitor bracket.
➤ Fit side covers into place (fig. j, page 8).
8

Cleaning and caring for the camera

A
NOTICE! Beware of damage
Do not use any sharp or hard objects for cleaning since they may damage the device.
➤ Clean the camera with a soft, damp cloth from time to time.
EN
Cleaning and caring for the camera
17