Table of Contents
Advertisement
SHOT TRANS
Select this setting to set the transition time
and curve. See page 42 for details on using
the shot transition function.
TRANS TIME
x
Select transition time ([3.5 sec] to [15.0
sec] seconds, the default setting is [4 sec]).
TRANS CURVE
x
Select the transition curve. The transition
curve changes as follows.
*1: parameter level
*2: transition of time
LINEAR
Make the transition linearly.
*
1
*
2
B SOFT STOP
Make the transition slowly at the end.
*
1
*
2
SOFT TRANS
Make the transition slowly at the
beginning and end, and linearly in
between.
*
1
*
2
b Note
• You cannot change [TRANS TIME] and
[TRANS CURVE] settings during store, check,
or execution of [SHOT TRANS]. Cancel
[SHOT TRANS] setting by pressing the
ASSIGN button 1 several times before changing
[TRANS TIME] or [TRANS CURVE] setting.
DV FRAME REC
You can record pictures with a stop-motion
animated effect by alternately recording a
few frames and then moving the subject a
little. Operate your camcorder using the
Remote Commander to prevent camera
shake.
B OFF
Select to record in the standard recording
mode.
ON (
)
Select to record pictures using the DV
FRAME REC function.
1 Select [ON] by the SEL/PUSH EXEC
dial.
2 Press the MENU button to hide the
menu screen.
3 Press the REC START/STOP button.
A picture (approximately 5 frames) is
recorded, and your camcorder enters
the standby mode.
4 Move the subject and repeat step 3.
b Note
• When you use frame recording continuously,
the remaining tape time will not be indicated
correctly.
• The last scene will be longer than other scenes.
• You cannot record index signals during frame
recording.
• This is automatically set to [OFF] if you turn the
power off and back on.
BACK LIGHT
When you set [BACK LIGHT] to [ON], .
is displayed and the back light function is
enabled (the default setting is [OFF]).
b Notes
• The back light function is canceled when you
set [SPOTLIGHT] to [ON].
59
Continued ,
Advertisement
Table of Contents
