Installation Guide Power Supply
5.2 Mounting
All devices can be attached to a back wall using the mounting tabs (see dimensions chapter 8). Operation in
any assembly position possible. The distance between the surrounding components and the air admission
and air exit holes should be at least 50 mm.
Please ensure that exhaust air is not immediately sucked in again.
6 Explanation of symbols
PE
L1 / L2 / L3
+ / -
Relay OK/FAIL
OFF
NTI AG / LinMot
Protective conductor
Do not use supply without PE connection!
Mains phases
Load connection
Monitoring connections
Control connection
Power range 1000 W
ENG
Page 7 / 12