Installation Guide Power Supply
5.2 Mounting
It can be mounted on a 35mm mounting rail according DIN EN50022, by means
of a wall or universal bracket on a mounting plate.
There should be a distance of at least 20 mm between the air inlets and outlets
and the surrounding devices. Please ensure that the air extracted is not
immediately sucked in again.
6 Explanation of symbols
L1 / N
PE
+ / -
Relay OK/FAIL
Control signal OFF
DIP - switch
UP / DOWN - switch
7 Notes
7.1 DIP-switch position
NTI AG / LinMot
Protective Earth
Do not use supply without PE-connection!
Mains phase / neutral conductor
Functional Earthing
Loadoutput (Vo)
Monitoring connections
External on/off
Selection boost- and parallelmode
Adjust the output voltage
Power range 480 W
DE
Page 7 / 12