Special 3-Shoe Clutch Reassembly - Morini Franco Motori S6-C COMPETITION Service Manual

SPECIAL 3-SHOE CLUTCH REASSEMBLY

Grassare = Lubricate
Apply a thin film of molycote grease on the shoe-holder plate.
Insert the clutch shoe socket screws.
Lubricate the outer diameter working zone of the 3 bushings with
molycote grease.
Insert the bushings in the clutch shoe fulcrums.
Position and install the clutch shoes on the shoe-holder plate using
the bushings as centering references.
Apply a thin film of molycote grease on the working area of the flat
spring.
Assemble the flat spring on the clutch with the 3 clutch shoe
retainer pawls and tighten.
Tightening torque 5.8 - 6.8 Nm
Lubricate the square holes in the flat spring and insert the 3 screw
coupling.
Grassare = Lubricate
Insert 7 Belleville washers in each hole
maintaining the correct assembly configuration.
See figure.
S
Sede molle = Spring seat.
Place 2 balls and 1 spring in each of the 3 special clutch
adjusting screws.
Install the 3 adjusting screws making sure that the balls and the
the springs remain positioned correctly in the screw housings.
Page 40
ENGINE
S6 / C