Clutch Cover - Morini Franco Motori S6-C COMPETITION Service Manual

DIAGRAM

CLUTCH COVER

DESCRIPTION
Drive the WATER CIRCUIT DELIVERY
PIPE into place
Assemble the SPRING on the sliding
gear as shown on the figure.
Lubricate the inside of the spring using
GR MU/3 grease.
Assemble the SLIDING GEAR on
the cover and secure the SPRING
between the two stops.
Assemble the SPACER RING and
O-RING on the KICK STARTER
SHAFT.
Lubricate the O-ring area using
GR MU/3 grease.
Lubricate the KICK STARTER
SHAFT in the clutch cover operating
zone using grease type MOLYCOTE.
Install KICK STARTER SHAFT in the
clutch cover and make sure that the
gear section is engaged properly with
the sliding gear.
After assembly check that the spring
of the sliding gear is correctly
positioned between the two stops.
Page 34
ENGINE
S6 / C
TOOL
NOTES
CODE
143167