S6 Oil Mixer Pump - Morini Franco Motori S6-C COMPETITION Service Manual

DIAGRAM

S6 OIL MIXER PUMP

DESCRIPTION
Preassemble the 2 BEARINGS and
SPACER on the OIL MIXER PUMP
DRIVE SHAFT and secure with 2
SNAP RINGS.
The print on the bearings should face
the drive end of the shaft.
Lubricate the bearing housing.
Drive the OIL MIXER PUMP DRIVE
SHAFT UNIT into the half crankcase
flywheel side.
Insert the CLEARANCE SPACER.
Assemble the BEARING SNAP
RING.
Insert the DRIVE BELT onto the
DRIVEN PULLEY.
Install the pulley on the oil mixer pump
shaft and the drive belt onto the splined
part of the crankshaft.
Assemble the oil mixer pump on the
support bracket and tighten the
screw M5x12.
In order to simplify the assembly
operation of the oil mixer pump,
make sure that the timing of the
driven pulley and the oil mixer
pump shaft do match.
Install the BRACKET with OIL
MIXER PUMP into the housing of the
half crankcase flywheel side.
Page 38
ENGINE
S6 / C
TOOL
NOTES
CODE
143155
143342
Tightening torque
5 - 6 Nm