Step 2: Connect The Aurender To Power; Step 3: Connect The Aurender To Local Area Network - Aurender W20 Quick Start Manual

STEP 2: Connect to Power
Using the included power cable, connect your Aurender to a 110/220V (depending on your region)
electrical outlet or a power conditioner/surge protector.
Note: Your Aurender product comes with a generic IEC power cable. However, many Aurender
customers choose to use an upgraded power cable for optimal sound. Please consult your hifi dealer for
cable recommendations.
STEP 3: Connect to Local Area Network (LAN)
W20/N10/A10/X100L/N100H/N100C/ACS10/A100
Your Aurender server must be connected to your router via a hard-wired Ethernet connection.
Aurender servers do NOT have any WiFi connectivity (this is by design - most WiFi networks are
unreliable and subject to drop-outs and limited bandwidth).
In cases where your listening room location makes it physically impossible to run an Ethernet
connection back to the router, you may use a WiFi extender or Ethernet-over-powerline adapter to
establish connectivity. Please contact Aurender Support for assistance.
Below is a diagram of a common connection schematic. Your network configuration may vary:
USB WiFi Adapter (optional)
In case your listening room does not have access to a wired LAN connection, you can use a
USB WiFi adapter ("dongle") to establish a one-to-one connection between your iPad and your
Aurender. In this scenario, you will not have Internet access for streaming, but you will be able to
browse and play content that is stored on your Aurender's local storage:
1. Consult support@aurender.com for an up-to-date list of compatible USB WiFi adapters.
2. Plug the USB WiFi adapter into a USB data port on the back of your Aurender.
3. In your iPad WiFi settings, select the WiFi network that is named after your Aurender.
4. The default password will be "aurender12345"
- 5 -