Getting Started; Charging The Battery Pack - Sony DSC-P2 Operating Instructions (primary manual) Operating Instructions Manual

Charging the battery pack

1
, Open the battery/"Memory
Stick" cover.
Slide the cover in the direction of the arrow.
• When charging the battery pack, make
sure the camera is not turned on
(page 14).
• The camera operates only with the
"InfoLITHIUM" battery NP-FC10 battery pack
(C type) (supplied). You cannot use any other
battery pack (page 95).
10
O P E
N
2
, Insert the battery pack, and
close the cover.
Insert the battery pack with the v mark
facing toward the battery compartment as
illustrated above. Make sure the battery
pack is properly inserted, then close the
cover.
• While pushing the battery eject lever down
using the front edge of the battery pack, you
can easily insert the battery pack.
Battery eject lever

Getting started

Jack cover
DC plug
3
AC power adaptor
, Open the jack cover, and
connect the AC-LS1A AC
power adaptor (supplied) to the
DC IN jack of the camera.
Open the cover in the arrow direction as
illustrated above. Connect the plug with the
v mark facing up.
• Do not short the DC plug on the AC power
adaptor with a piece of metal. This may cause a
malfunction.
• Clean the DC plug of the AC power adaptor
with a dry cotton bud. Do not use the dirty plug.
Use of the dirty plug may not properly charge
the battery pack.