Miele CVA 6805 Operating And Installation Instructions page 79

Problem
F73 or
Check the brew unit
F227, F228, F229, F230
F233
Cause and remedy
The brew unit cannot be positioned correctly, or it is
dirty and the ground coffee cannot be processed.
 Check whether you can remove the brew unit (see
"Cleaning and care - Brew unit").
 Remove and clean the brew unit (see "Cleaning
and care – Brew unit").
 Push the coffee ejector of the brew unit into the
correct position (see illustration).
 Push the waste container and the water container
back in the machine. Do not insert the brew unit.
Close the front and switch the machine on with the
On/Off sensor .
This will initialise the brew unit motor and put it back
into the start position.
 When
Insert the brew unit
open the front and replace all the parts back in the
machine. Close the front.
If the brew unit cannot be removed:
 Switch the machine off with the On/Off sensor .
Wait for approx. 2 minutes before switching it back
on again.
There is a fault with the automatic spout adjustment.
 Confirm the message with
The automatic spout adjustment will be deactivated
during drink preparation whilst the machine remains
switched on. You can still make drinks.
Problem solving guide
appears in the display,
.
OK
79