Applying The Label To The Supervisor Engine; Troubleshooting - Cisco PFC4 Installation Note

Step 2
Hold the right edge of the card with your right hand and the rear left corner with your left hand. Gently lift the card with
both hands simultaneously and remove the card from the supervisor engine.
Figure 6: Removing PFC4
Step 3 Place the card on an antistatic mat or antistatic foam pad.

Applying the Label to the Supervisor Engine

The policy feature card kit includes a label. Apply the label to the upper-left corner of the supervisor engine front panel.
Figure 7: Applying the Label

Troubleshooting

The following table provides troubleshooting tips that you can use if the policy feature card installation is not successful:
Table 1: Troubleshooting
Problem
The supervisor engine fails online diagnostics.
Severity—Low
10
Solution
Remove the supervisor engine from the chassis and make sure
that all the securing screws and cap nuts are tight. See
4: Installing the Supplied Screws, on page 7
Figure