1. Temporarily install the repeater within the CM coverage area.
2. Move the All-In-One Headset or Belt Pack to the area where they will be used and
check that communication is smooth and there are no disconnections.
•
If communication is not smooth, re-install the repeater in a different
location.
3. If the temporary installation location is suitable, install the repeater completely.
•
For details about wall mounting, refer to "3 Wall Mounting (Page 17)".
Installation Examples
•
If walls or obstacles exist between communicating devices, the signal may become
weak or disconnected.
Belt Pack
•
If 2 repeaters are registered to the same CM, do not place them near each other.
Doing so may cause signal interference or noise.
Repeater
Lane B
CM
(
Center Module
Repeater
2 Procedure Overview
All-In-One
Headset
Lane A
)
1
15