P) Switching The Flashing Signal In Normal Mode On/Off - Renkforce 1359882 Operating Instructions Manual

p) Switching the Flashing Signal in Normal Mode On/Off

In regular operation, the code lock will wait for input of a user code or a transponder. The left LED
flashes briefly every second. This flashing signal also serves to verify function of the code lock.
If this flashing is annoying (or too noticeable), you can switch it off.
Proceed as follows:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Select the desired function:
Flashing signal off
Flashing signal on (default setting)
• Confirm your input with the
• The code lock emits two beeps; programming is saved.
106
.
button.