Sony Handycam DCR-SR90E Operating Manual page 15

5
The CHG (charge) lamp turns off
when the battery is fully charged.
Remove the AC Adaptor from the
DC IN jack on your camcorder.
• Remove the AC Adaptor holding both your
camcorder and the DC plug.
To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
BATT (battery)
release lever
• When you remove the battery pack, make sure
that none of the respective lamps of the POWER
switch (p.17) is on.
When storing the battery pack
Use up the battery pack completely if you do
not intend to use it for a long time (p.93).
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
Charging time (full charge)
Approximate time (min.) required when you
fully charge a fully discharged battery pack.
Battery pack
NP-FP50
NP-FP60 (supplied)
NP-FP70
NP-FP71
NP-FP90
Charging time
125
135
155
170
220
Recording time
Approximate time (min.) available when you
use a fully charged battery pack.
Continuous
Battery pack recording
time
NP-FP50
NP-FP60
(supplied)
NP-FP70
NP-FP71
NP-FP90
* Typical recording time shows the time when you
repeat recording start/stop, turning the power on/
off and zooming.
• Times shown vary according to the following
conditions.
– Top: When the LCD backlight turns on.
– Middle: When the LCD backlight turns off.
– Bottom: Recording time when recording with
the viewfinder while the LCD panel is closed.
Typical
recording
time*
065 030
070 035
070 035
100 050
110 055
110 055
135 065
150 075
155 075
165 080
180 090
185 090
250 125
270 135
275 135
Continued ,
15