Table of Contents
Advertisement
5
The CHG (charge) lamp turns off
when the battery is fully charged.
Remove the AC Adaptor from the
DC IN jack on your camcorder.
• Remove the AC Adaptor holding both your
camcorder and the DC plug.
To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
BATT (battery)
release lever
• When you remove the battery pack, make sure
that none of the respective lamps of the POWER
switch (p.17) is on.
When storing the battery pack
Use up the battery pack completely if you do
not intend to use it for a long time (p.93).
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
Charging time (full charge)
Approximate time (min.) required when you
fully charge a fully discharged battery pack.
Battery pack
Charging time
125
NP-FP50
135
NP-FP60 (supplied)
155
NP-FP70
170
NP-FP71
220
NP-FP90
Recording time
Approximate time (min.) available when you
use a fully charged battery pack.
Continuous
Typical
Battery pack
recording
recording
time
time*
065
030
070
035
NP-FP50
070
035
100
050
NP-FP60
110
055
(supplied)
110
055
135
065
150
075
NP-FP70
155
075
165
080
180
090
NP-FP71
185
090
250
125
270
135
NP-FP90
275
135
* Typical recording time shows the time when you
repeat recording start/stop, turning the power on/
off and zooming.
• Times shown vary according to the following
conditions.
– Top: When the LCD backlight turns on.
– Middle: When the LCD backlight turns off.
– Bottom: Recording time when recording with
the viewfinder while the LCD panel is closed.
Page 15
Continued ,
Hide quick links:
Advertisement
Table of Contents
