Advertisement
Connecting and Mounting eW Burst Powercore Landscape Fixtures
eW Burst Powercore Landscape fixtures feature a 1/2 in NPT threaded post for
installing to standard junction boxes, stanchion mounts, posts, stakes, and other
landscape mounting accessories.
Make sure the power is OFF before mounting and connecting eW Burst Powercore
fixtures.
1. Mount junction boxes and any landscape mounting accessories in accordance with
the lighting design plan.
2. If installing fixtures in a series, pull 3-conductor copper wire between the junction
boxes. If installing fixtures in parallel, pull 3-conductor copper wire from line
power to a common junction box, and from the common junction box to each
fixture's junction box.
We recommend the use of 12 AWG (2.05 mm), stranded 3-conductor copper
wire.
3. Thread the locking nut onto the eW Burst Powercore Landscape threaded post.
4. If installing in a damp or wet location, insert the fixture cable through a junction
box gasket before making wire connections. When attaching the junction box
cover, ensure that the gasket is compressed evenly.
5. Use wire nuts to connect line, neutral, and ground.
6. Tuck wire connections into the junction box or mounting accessory.
7. Using a 33 mm wrench, torque the locking nut to 25 ft-lb (33.9 Nm). Do not
overtighten.
25 ft-lb (max)
33.9 Nm (max)
1.19 in
(33 mm)
22
eW Burst Powercore
Product Guide
Ensure that all junction boxes are
E
suitable for the environment and that all
wiring between junction boxes complies with
local codes.
Advertisement
