Advertisement
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Examples
This example shows how to configure a third-party SFP on a Cisco ISR G2 Series Router:
Router# configure terminal
Router(config-if)# service unsupported-transceiver
Router(config)# interface ethernet 0/3/0
Router(config-if)# media-type sfp
Router(config-if)# speed 100
Router(config-if)# shutdown
Router(config-if)# no shutdown
Router(config-if)# exit
Router(config)# exit
Additional References
The following sections provide references related to EHWIC 1 GE-SFP-CU.
OL-24318-02
Command or Action
interface type slot/subslot/port number
Example:
Router(config)# interface ethernet 0/3/0
media-type sfp
Example:
Router(config-if)# media-type sfp
speed value
Example:
Router(config-if)# speed 100
shutdown
Example:
Router(config-if)# shutdown
no shutdown
Example:
Router(config-if)# no shutdown
exit
Example:
Router(config-if)# exit
Router(config)#
Configuring Gigabit Ethernet Enhanced High-Speed WAN Interface Cards
Additional References
Purpose
Selects an interface to configure.
Changes media type to SFP.
Configures the speed of the interface.
For 100BASE SFPs, configure the
Note
speed to 100 Mbps only. Similarly,
for 1000BASE SFPs, configure
the speed to 1000 Mbps only.
Disables the interface, changing its state
from administratively UP to
administratively DOWN.
Enables the interface, changing its state
from administratively DOWN to
administratively UP.
Exits the configuration mode and returns
the global configuration mode.
15
Advertisement
