Sony Handycam DCR-DVD7E Operating Manual page 61

DATA CODE
You can check the display information
recorded automatically (data code) during
playback.
 OFF
Data code is not displayed.
CAMERA DATA
Displays the camera setting data of
recorded images.
DATE/TIME
Displays the date and time of recorded
images.
CAMERA DATA
Movie
60min
Still image
60min
 SteadyShot off
 Exposure
 White balance
 Gain
 Shutter speed
 Aperture value

Exposure value
DATE/TIME
60min
 Date
 Time
0:00:00
VIDEO
AUTO
100 AWB
9dB
F1. 8
10/10
VIDEO
7
OEV
5
60
F1. 8
6
0:00:00
VIDEO
8
1 1 2005
9
11:23:45
The data code is displayed on the TV screen if
•
you connect your camcorder to a TV.
The indicator toggles through the following
•
sequences as you press DATA CODE on
the Remote Commander: DATE/TIME 
CAMERA DATA  OFF (no indicator).
Depending on the disc condition, bars [--:--:--]
•
appear.
The setting returns to [OFF] when you have
•
the power source disconnected from your
camcorder for more than 5 minutes.
DISC REMAIN
 AUTO
Displays the remaining disc indicator for
about 8 seconds in situations such as those
described below.
When you check the disc remaining by
•
sliding the POWER switch to
or (Still).
When you set the POWER switch to
•
(Movie) or (Still), then press DISP/
BATT INFO to switch the indicator from
off to on.
When the remaining capacity of the disc is
•
less than 5 minutes for
images for (Still).
When you start recording from the line
•
input.
ON
Always displays the remaining disc
indicator.
REMOTE CTRL (Remote control)
The default setting is [ON] so that you can
use the Remote Commander (p. 37).
Set to [OFF] to prevent your camcorder
•
from responding to a command sent by other
equipment's remote control.
The setting returns to [ON] when you have
•
the power source disconnected from your
camcorder for more than 5 minutes.
(Movie)
(Movie) or 30
61