Table of Contents
Advertisement
CHAPTER 3 WIRELESS SETTINGS
Wireless Local Area Networks (WLANs) allow the SB1 to communicate wirelessly inside a building. Before
using the SB1 on a WLAN, the facility must be set up with the required hardware to run the WLAN (sometimes
known as infrastructure). The infrastructure and the SB1 must both be properly configured to enable this
communication.
Refer to the documentation provided with the infrastructure (access points (APs), access ports, switches,
Radius servers, etc.) for instructions on how to set up the infrastructure.
Once the infrastructure is set up to enforce the chosen WLAN security scheme, use the Wireless Settings
software (Fusion) to configure the SB1 to match the WLAN settings.
Overview
The Wireless Settings software contains applications with which to create wireless profiles. Each profile
specifies the security parameters to use for connecting to a particular WLAN as identified by its Extended
Service Set Identification (ESSID). The software also allows the user to control which profile out of a set of
profiles is used to connect. Other applications allow the user to monitor the status of the current WLAN
connection and to invoke diagnostic tools for troubleshooting.
To access Wireless Settings, touch Home button >
Wireless Settings Window
Figure 3-1
The Wireless Settings screen contains the following options:
Simple Setup
•
Profiles
•
>
> Advanced Settings > Wireless Settings.
Advertisement
Table of Contents
