Motorola SB1 Integrator Manual page 17

Calibration Screen
Figure 1-3
Leave the SB1 in the cradle until it is fully charged. The LED indicates the SB1 battery charging status. The
battery fully charges in approximately four hours. See
When the LED lights green remove the SB1 from the cradle.
Carefully press and briefly hold finger tip on the center of the Calibration screen target. Repeat the procedure
as the target moves and stops at different locations on the screen. After the calibration settings are input, tap
the screen to save the new calibration settings.
LED Indicator
Table 1-1
LED
Off
Slow Blinking Amber
Solid Green
Fast Blinking Amber
When using the SB1, if the battery charge falls below a predetermine level, it shuts down and displays the
Battery Discharged screen.
Battery Discharged Screen
Figure 1-4
When this occurs, immediately recharge the SB1 battery by placing it into a charging cradle. The Battery
Charging screen appears on the display indicating that the battery is charging.
SB1 not placed correctly in the cradle.
The cradle is not powered.
SB1 is not functioning properly.
SB1 is charging.
Charging is complete.
Charging error.
for charging status indications.
Table 1-1 on page 1-3
Indication
Initial Setup 1 - 3