Unpacking And Placing The Unit - M2TECH JOPLIN MKIII User Manual

JOPLIN MKIII
384 H /32bit ANALOG-TO-DIGITAL CONVERTER
k z
REVISION P A – APRIL 2019
R

1. Unpacking and placing the unit

Lay the package on a table and open the external box by removing or cutting the adhesive
tape seal. Then extract the internal box and open it by lifting the front wing. The following
items are included:
 one JOPLIN MKIII ADC;
 one wall adapter;
 one A-B USB cable;
 a remote control;
 two AAA batteries.
Should one or more item be missing, please contact your retail dealer.
Remove the JOPLIN MKIII from the foam enclosure and place it onto a stable base, far from
heat sources. Avoid full sunlight on the unit. Allow for ample room around the unit for
venting.
The JOPLIN MKIII is a high efficiency device; therefore it doesn't produce relevant heat
during its operation. Regardless, it's recommended to guarantee an adequate air flow
around the unit. Moreover, every time it will mainly be operated by remote control, it's
recommended to place it so as the remote control's infrared signals can easily reach its
front panel.
Avoid smoke, moisture, dirt and liquids from reaching the unit. Please note that any signs
of abuse will void warranty coverage.
7
M2Tech
www.m2tech.biz
Copyright © 2019, M2Tech Srl