Tractor Assembly; Ground Speed Control Lever Assembly; Seat Assembly - Snapper ZTR 800X Series Dealer Setup & Adjustment Instructions Manual

800X Series Zero-Turn Rider - 61" & 72" Mower Deck

Tractor Assembly

Ground Speed Control Lever Assembly

1. Remove the ground speed control lever and mounting
hardware from the handle bar box.
NOTE: There is a LEFT-HAND and a RIGHT-HAND ground
speed control lever . When assembled to the control lever
mount, the control lever base should be pointing towards the
rear of the machine as shown in Figure 4.
2. Install the ground speed control levers (A, Figure 4)
onto the control lever mount (C) using the 5/16-18 x 1"
bolts, 5/16" lock washers and 5/16" flat washers (B).
Prior to tightening the bolts, align the levers with each
other (see Ground Speed Control Lever Adjustment).

Seat Assembly

1. Unpack the seat.
2. Install the seat onto the seat mount plate and secure with
the 5/16-18" nylock flange nuts (A, Figure 5).
4
A
Figure 4. Ground Speed Control Lever Installation
A. Ground Speed Control Lever
B. 5/16-18 x 1" Bolt(s), 5/16" Lock Washer(s) & 5/16"
Flat Washer(s)
C. Control Lever Mount
A
A
Figure 5. Install the Seat & Connect the Harness
A. 5/16-18" Nylock Flange Nuts
ferrismowers.com | snapperpro.com
B
C