Remove The P-Board - Panasonic TH-58PX600U Service Manual

6.6.

Remove the P-Board

Caution:
To remove P.C.B. wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Disconnect the couplers (P2, P5, P9, P10, P11, P12, P23
and P25).
2. Remove the screws (×6
3. Remove the screws (×21
4. Disconnect the couplers (CN01-CN08, CN02-CN06 and
CN03-CN04).
5. Remove the screws (×10
) and remove the P-Board unit.
) on the back side.
).
6. Remove the molding props (×9
7. Remove the P(P-1)-Board.
8. Remove the molding props (×5
9. Remove the P(P-2)-Board.
Note:
When assembling the P(P-1)-Board and the P(P-2)- Board,
the position of each hole of the insulation sheets(A, B, C, D)
is set to the position of each hole of the P(P-1)-Board and
the P(P-2)-Board and then assemble them. (
indicate setting positions.)
11
TH-58PX600U
).
).
marks