Sony BDV-F700 Operating Instructions Manual page 17

When installing the speakers on a wall
Caution
• Contact a screw shop or installer regarding the wall material or screws to be used.
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Sony is not responsible for accidents or damage caused by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
Required preparation for BDV-F500
You cannot install the speaker with the speaker stand attached. Be sure to remove the speaker stand
before installing the speaker on a wall.
1
Remove the screws (pre-installed) at the bottom of the speaker.
These screws are used when reassembling the speaker. Be sure not to lose the screws.
2
Detach the speaker stand.
Screws
17
GB