Screws (With Washer) - Sony BDV-F700 Operating Instructions Manual

Note
• Place the speakers on a flat and firm floor (not on thick pile carpet, for example).
• Leave a space for inserting/ejecting the disc (approximately 15 cm) to the right (disc slot) side of the unit when
placing an object nearby.
Approximately 15 cm
• Use caution when placing the speakers and/or speaker stands attached to the speakers on a specially treated (waxed,
oiled, polished, etc.) floor, as staining or discoloration may result.
• Do not lean or hang on a speaker, as it may fall down.
• Image distortion on the TV screen may occur depending on the location of the subwoofer. In this case, place the
subwoofer away from the TV.
• Do not block the ventilation slots of the unit (page 8).
• Place both front speakers the same distance apart from the listening position.
• The front speakers should be placed at least 0.6 m apart.
• Place the front speakers forward from the TV. Make sure there are no reflecting obstacles in front of the speakers.
• Both front speakers should be pointed straight forward. Do not place the speakers at an angle.
To set the speakers at a vertical angle
(BDV-F500 only)
You can select the angle for the front speaker: vertical or upward. (The speakers are set to an upward
angle at the factory.)
1
Remove the screws (pre-installed) at the bottom of the speaker.
These screws are used when reassembling the speaker. Be sure not to lose the screws.
2
Detach the speaker stand.
Screws
15
GB