Other Parameters - NovaTec NovaDrier ND-7 Instruction Manual

5.3 Changing The Drying Temperature
NOTE: The ND dryer has two heaters: UPPER and LOWER, each with its own temperature control.
Both controls must be adjusted when changing the process drying temperature.
Both displays will default to show the actual temperature.
UPPER HEAT
SELECT
ENTER
LOWER HEAT
SELECT
ENTER
1. Press the UPPER or LOWER temp adjustment buttons,
from displaying actual drying temp, to display that heater's set point.
2. While set point is displayed, press
3. The control will revert back to display actual temperature and the dryer's heaters will
respond, displaying the new set point.
4. Adjust both UPPER (top) and LOWER (bottom) temperatures to the same set point
NOTE: The SELECT

5.4 Other Parameters

There are other dryer parameters that are pre-set at the factory and they should
not be changed unless directed to do so by an authorized NOVATEC Service
technician.
Instruction Manual IM ND 3 JAN 2017
to increase the set point, or
and ENTER
for changing the drying temperature.
Instruction Manual ND IM 3 JAN 2017
Drying
Temperature
Adjustment
Push Buttons
or , once, to switch
to reduce the set point.
buttons are NOT required
value.
Page 14