Mitsubishi Electric PEAD Series Service Manual page 44

DISASSEMBLY PROCEDURE
5. Fan and fan motor
1. Removing the filter and the bottom plate
(1) Push down the tab on the filter, and pull out
the filter in the direction of the arrow 1.
(2) Remove the fixing screws on the bottom
plate (J) to remove it.
2. Removing the fan casing (bottom half)
(1) Squeeze the tabs on the fan casing to
remove it in the direction of arrow 2.
3. Removing the motor cable
(1) Remove the motor cable threw the rubber
bush.
4. Removing the fan motor and the Sirocco fan
(1) Remove the two motor fixing screws to
remove the motor and the Sirocco fan in the
direction of arrow 3.
(2) Remove the four fan case fixing screws to
take the top half of the fan casing off.
HWE16080
Exercise caution when removing heavy parts.
(J)
Fig. 8
Fig. 9
Fig. 10
Fig. 11
44