Cleaning And Maintenance - Sharp EM-150M-WH Instruction Manual

7. Disconnect from power supply once finished. Disassemble the mill
from the unit, keep the mill container downward and turn
it anticlockwise (see fig.4), then empty the container and serve.
8. Do not run the appliance for more than  minute per time, and only wait until the
unit is FRROHG IRU DURXQG PLQXWHV before performing next operation cycle.
WARNING:
1. For the mill, never operate the appliance continuously for more than 3 minutes
per time.
2. Blades are very sharp. Handle with care.
3. Do not operate without the jar cover in place.
4. Do not disassemble the jar or container from the jar base or container base in
general condition.

CLEANING AND MAINTENANCE

Make sure to disconnect appliance from power supply before cleaning. Handle the
cutting blade carefully during cleaning. Use soft sponge.
For blending attachment
1. Fill in room temperature water about half of the jar and turn the speed selector
to "Pulse" position without releasing it for about 30 seconds.
2. Dismantle all detachable parts
rinse it under running water, then detach the blade assembly from the jar
assembly, and take the blade assembly out. In addition, detach the measure cup
from the jar cover. Rinse the jar, blade, jar cover and measuring cup under
running water.
3. Wipe the outer surface of motor unit and with a soft and dry cloth.
NOTE: Do not use abrasive cleanser and never immerse motor unit in water for
cleaning.
4. Dry all parts and then assemble them. The method of assembling blending
attachment just is in opposite of its detaching sequence.
NOTE: If any problem has been encountered during using, never disassemble
the motor unit by yourself. There are no user serviceable parts inside. Only
contact the authorized service facility for examination and repair.
Disassemble the Jar from the motor unit and
.
6