Sharp EM-150M-WH Instruction Manual page 5

the fruits or vegetables and water is 2:3.
NOTE: The blender is not applicable for beating egg white, mashing potatoes,
mixing dough, extracting juice from fruit and vegetable.
4. Replace jar cover on the jar and turn it clockwise.
NOTE: There is a safety interlock device at the side of jar cover, if the jar cover is
not assembled in place, the blender will not operate.
5. The ingredients may be added into the jar through the center opening of jar
cover during operation, then replace measuring cup if necessary. Let the tabs of
measuring cup aligns with the grooves of jar cover, put down and turn the
measuring cup by clockwise until it in place.
6. Ensure the speed selector at the "0" Position, then plug into power outlet and
turn the speed selector to the desired setting, there are four setting: 0, 1, 2,
PULSE. The "1" setting is the low speed; the "2" setting is the high speed. During
blending, you may turn the speed selector to "Pulse" Position without releasing it
if want to accelerate the process of blending.
NOTE: Make sure the jar cover is placed in position completely before operating,
and never open the jar cover during operation.
Pulse
To start pulsing, hold the knob to
this position
To stop pulsing, release the knob
7. Do not run the appliance for more than  minutes per time, and only wait until the
unit is cooled for around  minutes before performing next operation cycle.
8. Turn the Speed Selector to "0" position once the mixture has been blended to
your desired consistency.
9. Turn the jar anti-clockwise and remove it from the motor unit, carefully take down
Stop
To stop the appliance at any time
set the knob to this position
4
Lowest
Highest