How To Record Video From A Camera When Motion Is Detected; How To Record Radar Data When Motion Is Detected - Axis D2050-VE User Manual

AXIS D2050-VE Network Radar Detector
Setup

How to record video from a camera when motion is detected

This example explains how to set up the detector and a camera so that the camera starts recording to the SD card five seconds
before the detector detects motion and to stop one minute after.
Connect the devices:
1. Connect a cable from an I/O output on the detector to an I/O input on the camera.
Configure the I/O port of the detector:
2. Go to Settings > System > I/O ports and configure the I/O port as an output and select the normal state.
Create a rule in the detector:
3. Go to Settings > System > Events and add a rule.
4. Type a name for the rule.
5. From the list of conditions, select an include zone under Radar motion. To set up an include zone, see Add an include
zone on page 12
6. From the list of actions, select Toggle I/O while the rule is active and then select the port that is connected to the camera.
7. Click Save.
Configure the I/O port of the camera:
8. Go to Settings > System > I/O ports and configure the I/O port as an input and select the normal state.
Create a rule in the camera:
9. Go to Settings > System > Events and add a rule.
10. Type a name for the rule.
11. From the list of conditions, select Digital Input and then select the port that should trigger the rule.
12. From the list of actions, select Record video.
13. Select an existing stream profile or create a new one.
14. Set the prebuffer to 5 seconds.
15. Set the postbuffer to 60 seconds.
16. Select SD card from the list of storage options.
17. Click Save.

How to record radar data when motion is detected

This example explains how to set up the detector to start recording to the SD card five seconds before it detects motion and to
stop one minute after.
The recording will show the reference map with the trail of the moving object.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. From the list of conditions, select an include zone under Radar motion. To set up an include zone, see Add an include
zone on page 12
10