Cooling Timer - Mepu K-SERIES Operating Manual

6.4.2 Cooling timer

The start display of the cooling timer is shown at pos. (A). After the set time has lapsed and the
timer has stopped the equipment, the drying process has ended, pos (B).
Pos. (C) shows a situation when the Lock (2) key has been pressed, the keys are locked and are
released only after the Lock (1) is pressed again.
Setting the cooling time before drying
The cooling time is set by pressing the hh:mm keys. After the desired time has been set, press the
Start button. This confirms the set time, and the set time is displayed on the top row (red numbers).
When the dryer switches over into the cooling mode, the timer starts the count-down, and the
remaining cooling time is displayed on the timer (red numbers).
Modifying the time when the dryer is running.
The time can be modified either in the drying mode or in the cooling mode. Using the hh:mm keys,
select the new time setting, and press the Reset (1) button. The set time is displayed in red, which
means that it has been accepted. In the cooling mode, the new setting is the new cooling time. This
makes it possible to stop the cooling process, e.g. set the time as 1 min., and press Reset (1). After
one minute the cooling process ends and the dryer stops.
23 D00125-2019_EN