Mepu K-SERIES Operating Manual page 19

Factory settings
Unit
Fan thermostat
Burner thermostat 1 stage
Burner thermostat 2 stage
Overheat thermostat
Drying process setting
thermostat
Cooling timer
Level guard delay
Pre-cleaner setting
Pre-cleaner weight
Spreader disc
Main fan setting
Partial batch shutters or
central channel hatches
Feeding apparatus
hatches
Feeding speed
18
Type Factory
setting
Capillary
50 °C
Digital
90 °C
Digital
80 °C
Capillary
120 °C
Digital
50 °C
(30-50) °C
Digital 1h:30min
Digital
5s
Manual 1/2
Manual Right at the
bottom
Manual Holes 3 cm
open
Manual Fully open
Manual Open
Manual Closed
Electrical 5
Action
The fan starts when the temperature is
exceeded. Always make sure that the
dryer power is switched on.
Puts the 1 stage flame off at this
temperature. The nozzle has to be
dimensioned such that it does not put
the 1 stage flame off.
Puts the 2 stage flame off at this
temperature.
If the temperature
switches to overheat -> alarm.
Factory setting 50°C,
operating setting 30–50. If
the set value
switches over to cooling.
When the cooling is activated, the
clocks starts counting down the
cooling time. After the time has
lapsed, the unit is switched off.
Minimum value 1 min.
The period during which the dryer is
being filled after the sensor has given
the signal.
At the mid-point. If it is open too
much, grain can get mixed into the
debris.
Evens up the flow of grain into the
dryer.
Down, and the bottom holes open by
ca 3 cm.
Limits the air flow if necessary.
Normally open. For partial batches –
closed. Opens or shuts off the air flow
to the top drying cells.
To be kept closed Opened, if required,
for emptying.
At the mid-point. Measure the time
when emptying with the feeding
apparatus, and adjust the feeding
apparatus speed, if necessary.
D00125-2019_EN
is exceeded,
normal
is exceeded,