Electrical Switchboard - Mepu K-SERIES Operating Manual

5.3 Electrical switchboard

Electrical switchboard cabinet,
Signal lights and control buttons
The operation mode switch must be on 0-postion when using manual controls
Actuator
Emergency stop reset
Cooling
Drying
Dryer full
Rotation detector malfunction/reset
13
A. Group fuses and earth leakage circuit breaker. The actuators are
protected by fuses and an earth leakage circuit breaker.
B. Main switch. Under the protective cover. The electrical equipment of the
dryer can be disconnected from the power network. The switch must
always be turned to OFF position, when any maintenance work is carried
out.
C. Drying process selector switch, see section: 6. Operating the dryer, on page
20
D. Emergency stop button. The emergency stop button is used to stop the
dryer in case of an accident or emergency (may be used only in case of an
emergency).
The electrical switchboard has been pre-installed, adjusted and tested at the
factory.
Data label of the switchboard.
Using the number and the year of the label
you can order new electrical switchboard
labels, if necessary.
Actuator use
Resetting the emergency stop button. Before resetting, all
emergency stop buttons must be released. Emergency stop
buttons can be released by rotating or pulling them upwards.
After this, press the emergency reset button.
Lights up when the cooling is switched on.
Lights up when the drying is switched on.
Lights up when the dryer is full.
Lights up if the rotation detector has malfunctioned, stops the
bottom auger and the elevator. Press button to reset.
D00125-2019_EN