Mepu K-SERIES Operating Manual page 15

Overheat
Engine protection
Frequency converter malfunction
Channel fans
Workpause time relay
Feeder speed
Channel fans
Elevator
Bottom conveyor
Feeding conveyor
Precleaner
Feeder /Bottom fan
Main fan
Cooling timer
Work/pause time relay
Drying thermostat
Burner 2-flame thermostat
14
Light when overheat limit is reached
Channel aspirators can be switch off or put on during the
drying process.
Activate or deactivate work-pause time relay
Adjusts how quickly the grain rotates inside the dryer
Manual control of the elevator
Manual control of the elevator
Manual control of the bottom auger
Manual control of the feeding conveyor
position)
Manual control of the precleaner
Manual control of the feeder/bottom fan
position)
Manual control of the main fan
Under the protective cover
Adjusting the length of the cooling time. Cf section: Cooling
timer Cooling timer, page 22
Cf. section: Work/ pause time relay Work/ pause time relay,
page 25
Adjusting the temperature range of the drying; i.e. at what
temperature the drying will move on to cooling.
Adjusts the blasting temperature from the furnace to the
dryer.
The blower and the overheating thermostats are read
from the position of 9 o'clock. Both thermostats are
pre-set at the factory. See section: Factory settings,
on page 18
(Operation mode switch 0-position)
(Operation mode switch 0-position)
(Operation mode switch 0-position)
(Operation mode switch 0-
(Operation mode switch 0-position)
(Operation mode switch 0-
(Operation mode switch 0-position)
D00125-2019_EN