Mode Button; Timer Button; Sleep Button; Key Lock - Dometic AC-1351 Installation, Operation And Maintanance Manual

OPERATING INSTRUCTIONS FOR ADJUSTING THE THERMOSTAT
Temperature display
area
Display timer setting, set or ro om
temperature in C or F
Room temperature
setting button

Timer button

Press to activate on/off
timer programming mode
Fan speed button
Press to select auto, high,
medium or low fan speed
1. Power On/Off
ON/OFF

Press
2. Temperature setting
 Press
pressed, temperature display area will flash with the old temperature setting for 4 seconds. Should
there be no further key press it will then return to room temperature display in the range of 0C-50C.
 Press
and
temperature set range is 16C-30C or 60F-85F.
 Temperature setting is bypassed in Fan mode.
 Temperature display according to set temp. Press
is released. In degree F setting, 100 is shown as A0, 110 as B0, 120 as C0, 130 as D0, 140 as E0
and 150 as F0.
TEMP
TIMER
to start or stop the air conditioner.
or to decrease or increase the set temperature. When any of these buttons is
FAN
together for 5 seconds will change the temperature setting from C to F. Valid
SENSOR
ON/OFF
AUTO COOL
HIGH DRY
FAN MODE
MED HEAT
LOW FAN
FURNACE SLEEP
Furnace button
This button is valid in heatpump +
furnace model only
Press once to select furnace as
primary heating
Press again to cancel furnace as
primary heating
SLEEP
button for 5sec to show room temp until key
13
Infra red reception
To receive wireless handset sign al
On/Off button
Press once to start operation
Press again to stop operation

Mode button

Press to select cool, dry, heat ,
fan , or auto operation mode

Sleep button

Press once to select sleep mode
Press again to cancel sleep mode

Key lock