Setting Expression Pedal Presets; Notes And Specifications - Electro-Harmonix Superego+ Manual

SETTING EXPRESSION PEDAL PRESETS

Program and save EXP pedal presets by executing the following steps:
1. Insert an expression pedal into the EXP jack.
2. Tap the EFFECT footswitch, if necessary, to ensure that the effects are off.
3. Press and hold the EFFECT footswitch for more than one second. The green
Effects LED will start to blink.
4. Release the EFFECT footswitch.
5. Set the expression pedal to heel-down and set the 7 controllable knobs
(ATTACK, DECAY, RATE, DEPTH, THRESHOLD, LAYER and GLISS) to the
desired heel-down setting.
6. Put the expression pedal in toe-down position and set the same 7 knobs to
the desired toe-down setting. If you do not want a knob to change with the
expression pedal then do not turn it during this step.
7. NOTE: The expression pedal must be placed into the heel-down and toe-
down positions at least once during preset acquisition.
8. Press and hold the EFFECT footswitch.
9. The Effects LED will flash red to confirm that a preset has been saved. The
Red LED will only light with an expression pedal plugged into the EXP jack.
10. Release the EFFECT footswitch, the red LED goes solid. The solid red LED
indicates that an expression pedal preset has been saved and is active.
MORE ABOUT EXPRESSION PEDAL PRESETS
• To exit programming an expression pedal preset without saving changes, press
and release the EFFECT footswitch at any time before step 8 in the above
procedure.
• When a preset is active, turning any of the 7 control knobs will save that
knob's new setting as both the heel-down and toe-down setting. The EFFECTS
LED will flash red for half a second and then remain lit solid.
• To erase a preset, make sure the EFFECTS are off. Press and hold the
EFFECTS footswitch for 5 seconds. After one second the green LED will begin
flashing. After 5 seconds the green LED will flash quickly. Release the EFFECTS
footswitch and the preset will be cleared. The EFFECTS LED will light green
and the expression pedal controls the default parameter.

NOTES AND SPECIFICATIONS

• Buffered bypass
• Input impedance: 2.2M ohms (INPUT and RETURN jacks)
• Output impedance: 500 ohms (OUTPUT and SEND jacks)
• See p. 10 for a blank user template you can photocopy or use directly to
record your favorite personal settings.
• Go to ww.ehx.com/products/superego-plus to download a blank template you
can print and fill out to keep track of your favorite settings.
9