Table of Contents
Advertisement
Tutorials
Controlling Multiple Modules with a Single Setup
Note that the SPS4 is being used as the MIDI controller for all four of the modules. To be
able to control each of the four modules individually, we need to create a Setup with four
non-overlapping Zones, each of which will control a particular module. For our example,
let's say the following:
• We want only to use the SPS4 as a MIDI controller for the other modules
• All of our Modules will have the same panning, volume, velocity range, and bend
• The Foot Switch will act as a sustain pedal for only Module 1
• The Mod Wheel will affect only Module 2, for which it will act as a Mod Wheel.
• Control Knob Function 1 will affect only Module 3 and Module 4, for both of which
• The Zones will have the following ranges and affect only the following Modules set
Bank 0, Program 23
via Channel 4
E1
1. First, we need a Setup. Let's pick any factory Setup to work with. We will alter the
parameter values of the Zones in the steps to follow.
2. Let's now go into Edit Setup Mode by pressing the Edit Setup Function button. In this
Mode, we will alter the parameters of our Setup. See Edit Setup Mode on page 8-1 for more
information on the parameters of a Setup.
11-8
range.
it will act as a Volume control.
to the following MIDI Channels, Programs, and Banks:
Zone
Range
Zone 1
C6-G7
Zone 2
F4-B5
Zone 3
C3-E4
Zone 4
E1-B2
Module 4
Zone 4
B2
C3
Module
Module 1
Module 2
Module 3
Module 4
Module 3
Bank 3, Program 67
via Channel 3
Zone 3
C4
E4 F4
Channel
Bank
1
2
2
5
3
3
4
0
Module 2
Bank 5, Program 112
via Channel 2
Zone 2
B5 C6
Program
3
112
67
23
Module 1
Bank 2, Program 3
via Channel 1
Zone 1
G7
Advertisement
Table of Contents
