Bowers & Wilkins 96002 Manual page 7

B&W bike case
10
1.1
Slide the quick-releases into the ASF
mounting elements. Guide the springs so
that the thin areas of all springs are point-
ing inwards on the quick-release that is on
each side of a spring.
1.2
Lift the bike with one hand and pull the
gears slightly back with the other hand.
Place the rear drop end into the rear
mounting so that the top chain section
runs above the mounting element.
1.3
Guide the drop ends of the front wheel
fork to the front mounting element.
1.4
If the fork doesn't fit, you must adjust the
mounting element by loosening and slid-
ing on the front cantilever.
1.5
Then fix the frame onto the ASF; use the
quick-releases or full-floating axles on
your bike. Close the wheel fixings as you
would on the bike. Once everything is in
place, tighten all screws on the ASF with
a suitable torque key and a torque of 10-
12 Nm.
The handlebars must be driven in 90°.
i
For bikes with double bridge forks on
which this is not possible, please order
a corresponding adapter at info@b-w-
international.com or contact us on +49-
(0)5451/8946-0.
1.6
Turn the crank parallel to the chain bar
and fix the right pedal eye with a cable tie
to the chain bar.
1.7
Also fix the chain at the point where it
meets the chain wheel and where it leaves
it again. This means the chain cannot fall
and cause damage and the sharp edged
chain wheel is somewhat defused.
1.8
Switch to the lowest gear with the right
gear lever so that the rear derailleur is fully
on the inside.
bike case B&W
11