Table of Contents
Advertisement
Pa
6.5.3
Choosing the number of devices
Figure 9
Figure 10
Figure 11
ebm-papst A&NZ Pty Ltd
10 Oxford Road · Laverton North VIC 3026 · Phone +61 (03) 9360 6400 · Fax +61 (03) 9360 6464
ABN 33 115 927 556
NSW Phone +61 (02) 9827 6400 · NSW Fax +61 (02) 9827 6464 · NZ Phone +64 (09) 525 0245 · NZ Fax +64 (09) 525 0246
sales@ebmpapst.com.au · www.ebmpapst.com.au
Choose "a.Settings" by using
option.
Press
to edit the number of devices in use.
Select total number of devices that are to be connected by scrolling
. Press
once desired value is obtained (as shown in Figure
9).
The Univeral Gateway device recognises a maximum of 30 fans.
Offline Delay and Offline Recall are set a default of 10s and 2s
respectively.
User to choose mode of fan control by scrolling
Press
once desired option is selected.
On the same screen scroll down and push
option. Select "YES" for Enable Fan option by using
press
. Select "YES" for all fans that are to be active. All active
fans can be controlled by the administrator. If this option is selected
as "NO", you will not be able to configure the respective fan nor will
the fan show as an active device.
Exit screen by pressing
.
Choose value 12 for both "Ramp up time" and "Ramp down time" using
. Once desired value is selected press
"Run Direction" will have to be checked against the respective fan
Datasheet. If in doubt, consult your ebm-papst representative.
Run direction: right = clockwise; left = counterclockwise.
to scroll and press
to choose
.
for Enable Fan
and
.
Page 7 of 15
Advertisement
Table of Contents
