Table of Contents
Advertisement
Pa
Figure 15
6.5.6
Viewing real-time fan data
Figure 16
6.5.7
Alarm
In case the fans have been disconnected from the device or if they are not addressed appropriately the EC-FAN GATEWAY
will give off an audible alarm.
To view the alarm, press
. The description of the respective problem will be displayed in the alarm log.
Once you have viewed the alarm screen, press
Unless the problem is rectified, the EC-FAN GATEWAY will continue to indicate an alarm warning. The beeping sound will persist and the
description of the respective problem will be displayed in the alarm log.
ebm-papst A&NZ Pty Ltd
10 Oxford Road · Laverton North VIC 3026 · Phone +61 (03) 9360 6400 · Fax +61 (03) 9360 6464
ABN 33 115 927 556
NSW Phone +61 (02) 9827 6400 · NSW Fax +61 (02) 9827 6464 · NZ Phone +64 (09) 525 0245 · NZ Fax +64 (09) 525 0246
sales@ebmpapst.com.au · www.ebmpapst.com.au
Press
the desired speed as described in the below steps.
Speed is displayed in rpm. Press
desired speed value.
Press
will operate at requested speed.
Repeat speed if there is more than one fan in the
application. Note: following recovery from a power failure
the device will revert to the rpm value that is entered in
"manual value".
Return to the main menu by pushing
Pressing
specific fan that is desired.
. The beeping sound will cease.
to access edit mode. Here you can enter
or
to aquire
again once appropriate speed is selected. Fan
or
or
keys will allow the user to view data for the
.
Page 9 of 15
Advertisement
Table of Contents
