Status Screen; Figure 2-7: Status Menu; Figure 2-8: Example Of Status Screen - L3 comminications Trilogy ESI-2000 Pilot's Manual

ESI-2000
STATUS SCREEN (Refer to Figure 2-7)
When selected in the menu window, pressing the Select S button opens
the system status screen similar to Figure 2-8.
The status screen is only available in the menu list within the first 3
minutes after power is applied to the indicator and provides information
about the indicator as well as any fault and installation problems
detected during the Power-
On Self Test. The unit Serial
Number, operating hours,
battery temperature, and
battery charge capacity are
displayed on the System
Status page. The System
Ok message is always
shown unless an internal failure or Installation problem is detected and
listed on the screen.
Refer to Chapter 4 for a list of fault messages and detailed
information.
• Messages appearing with dim gray text preceded with a dash are
older messages that were detected prior to the latest application
of power. Older messages continue to be viewed for up to four
power cycles after it was first detected.
Press the + button to exit the status screen and return to normal
operation
Pilot's Guide

Figure 2-7: Status Menu

Figure 2-8: Example of Status Screen

Basic operation
2-5