10 Sony Projector Preparation For Tms; Screen To Screen (S2S) Network Setup; Screen To Screen Source Setup; Ntp Setup - Sony TMS Training Manual

Confidential
10 Sony Projector Preparation for TMS
There is some configuration of the Media Block (LMT) in order for it to correctly
interact with the TMS. These steps should be completed after the projector has been
aligned and setup using the SRXC software.
The following setups require an IP address schema. If customer does not have a pre-
defined one, please use the default schema on page 14.

10.1 Screen to Screen (S2S) Network Setup

Log on to the Media Block using the Projection Touchpanel (PJT)
(UN: super, PW: 0955)
Menu > Content > S2S Network Setup
Enter the following parameters:
IP Address:
Subnet Mask <Assume to be 255.255.255.0 unless otherwise stated>
Default Gateway < Default Gateway IP address from the IP Schema>

10.2 Screen to Screen Source Setup

This sets up the sources from which each projector can ingest material. Therefore the
projector needs to have all the other projectors setup as sources. For example
projector 1 of 9 screens would need screen 2-8 setup as sources.
Log on to the PJT (UN: super, PW: 0955)
Menu > Content > S2S Source
Enter a Name:
IP Address:
Add all other screens to the S2S sources.

10.3 NTP Setup

Log on to the PJT (UN: super, PW: 0955)
Menu > Maintenance > Clock Settings
Enter the following:
IP Address:
Save Settings.
October 15
Integrator Training, UK
Digital Cinema Deployment
<Projector S2S IP address from the IP Schema>
scr2 (do not use any spaces)
<Projector TMS IP address from the IP Schema>
<TMS Server IP Address>
41 of 49