Let's power ON the system and play the piano using the PLX bu on .
Reconnect the piano to the AC power outlet and then turn the power supply switch ON.
The PLX lights should begin to scan as the opera ng system is loaded.
Within ten (10) seconds at least one of these PNO
PLX light sequence:
Within ninety (90) seconds
#1 "Power" light turns green
#2 "System" = green
#3 "Network" = [The Network light indicates the status of the "Wired" Network. PNO3WB Ethernet Port connec on.]
Within two (2) minutes
Voice‐Prompt announcements should be heard from the speaker.
#6 "Prompt" light flashes yellow with audio.
Tap the bu on on the PLX box.
The piano should play and the "Power" light will flash.
Tap the bu on again to stop play.
If the piano did not play:
Check the cable and AC power connec ons.
Check that the power supply switch is on.
Check that the HI and LO lights are illuminated on the power supply.
Call QRS Technical Support @ 800‐247‐6557
Test Files
First, check that the processor's Playback Parameters are set to play the keys in the proper order.
Go to: System Setup / Performance Setup / Test Files
Play the Middle_c.cmp
Confirm that the middle "C" key plays.
Play Test‐Chorma c‐Velocity‐001.MID file.
The keys should play from bass to treble; 5‐84 on 80 note & 1‐88 on an 88 note system.
40
Adjustment Procedures
Power ON and Test PNO
3
bu on lights should illuminate.
3
test file
3