Jet JWDS-2244 Assembly And Parts List

Open Stand for JWDS-2244/-2550 Drum Sanders
•
Read and understand entire owner's manual for your drum sander before attempting assembly or operation.
•
Read and understand the warnings posted on the machine and in the manual. Failure to comply with all of
these warnings may cause serious injury.
•
Replace warning labels if they become obscured or removed.
•
Before operating, make sure the drum sander is firmly secured to the stand, and all fasteners in the stand
are tightened.
•
WARNING: This product can expose you to chemicals including lead which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
http://www.p65warnings.ca.gov.
Tools required for assembly:
6mm hex (Allen) wrench
12/14mm wrenches (a ratchet wrench with
sockets will speed assembly time).
Contents:
1 Shelf – A
2 Short rails – B
2 Long rails – C
4 Legs – D
1 Hardware Package, includes:
24 Carriage Bolts, M8x16 – HP1
24 Flanged Lock Nuts, M8 – HP2
4 Leveling feet – HP3
8 Flat washers 10mm – HP4
8 Hex nuts M10 – HP5
6 Soc. hd. cap screws M8x16 – HP6
8 Flat washers 8mm – HP7
Assembling stand
1. Assemble legs (D) to outside of Short Rails (B) with carriage bolts (HP1) and flanged lock nuts (HP2). Finger
tighten only.
2. Assemble Long Rail (C) on inside of legs and on top of Short Rails (B). Finger tighten only. NOTE: Flange of Long
Rail overlaps flange of Short Rail. See inset photo.
3. Turn stand upside down. Install shelf (A) into legs using carriage bolts and flanged lock nuts.
4. Insert leveling foot (HP3) into bottom hole of each leg with flat washers and hex nuts.
5. Turn stand right-side up, and push down on it to settle it, then tighten all flanged lock nuts on stand.
6. Level the stand by turning the leveling feet (HP3) in or out. When level, tighten hex nut (HP5) against leg flange.
Mounting sander to stand
CAUTION: Use an assistant to help lift and position the drum sander.
1. Position sander atop stand so that threaded holes of sander base align with holes in stand rails.
2. Fasten sander base to stand (from beneath) with the six (6) additional screws and washers provided with the stand.
3. Tighten screws securely.
JET
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
www.jettools.com
Assembly and Parts List

IMPORTANT SAFETY INSTRUCTIONS

Copyright © 2018 JET, a division of JPW Industries, Inc.
Part No. M-723540OS
Edition 2 10/2018