Frigidaire FPFU19F8RF Use & Care Manual page 6

INSTALLATION
Door Handle Mounting Instructions
1. Remove handle from carton and any other protective packaging.
2. Position handle end caps over upper and lower pre-installed shoulder bolts (A) that are
fastened into door, ensuring the holes for the set screws are facing towards the outside
of door if a single unit installation or the refrigerator door (if installing the matching
refrigerator).
3. While holding handle firmly against door, fasten upper and lower Allen set screws (B) with
supplied Allen wrench.
4. Repeat steps 2 and 3 to install handle (if installing the matching refrigerator). Ensure the
holes for the set screws are facing towards the refrigerator door.
Frigidaire Gallery
A
B
Ensure Handle Set Screws are Facing
Each Other with Doors Closed
NOTE

All set screws should be tightened and sub-flush (Allen set screw should be seated just below
the surface of the end cap) of handle end cap. The end caps should be drawn tight to door
with no gaps.
6
®
Single Unit Installation
Ensure Handle Set Screws are Facing
Each Other with Doors Closed.
Matching Refrigerator and Freezer Door
Handle Installation
Frigidaire Professional
A
B
Ensure Handle Set Screws are Facing
Each Other with Doors Closed.
®