Installation - Frigidaire FPFU19F8RF Use & Care Manual

Required Tools
You will need the following tools:
(OR)
Phillips™
Head or
#2 Square Drive
Head
OR
Socket
Wrench Set
CAUTION
DO NOT install the appliance where the temperature will drop below 55°F (13°C) or rise
above 110°F (43°C). The compressor will not be able to maintain proper temperatures inside
the unit.
DO NOT block the kick plate on the lower front of your appliance. Sufficient air circulation is
essential for the proper operation of your unit.
 NOTE
The exterior walls of the appliance may become quite warm as the compressor works to
transfer heat from the inside. Temperatures as much as 30ºF warmer than room temperature
can be expected.

Installation

Installation clearances:
• Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides - 3/8 inch
Top and Back - 1 inch
• Allow for trim kit if it is to be installed
with the unit.
 NOTE
If your unit is placed with the door hinge side
against a wall, you may have to allow additional
space so the door can be opened wider.
AND
OR
Adjustable ⅜" Fixed
Wrench Wrench
This Use & Care Guide provides general
operating instructions for your model. Use
the unit only as instructed in this Use & Care
Guide. Before starting the appliance, follow
these important first steps.
Location
• Choose a place that is near a grounded
electrical outlet. Do Not use an
extension cord or an adapter plug.
• If possible, place the unit out of direct
sunlight and away from the range,
dishwasher or other heat sources.
• Install the appliance on a floor that is
level and strong enough to support the
unit fully loaded.
1" (25 mm)
1"
(25 mm)
(10 mm)
INSTALLATION
Freezer
⅜"
⅜" (10 mm)
5